Assemble your button following the image and run both end of your leather through the opening.
DO NOT try to force the button together.
Squeeze just enough to align the openings.
Put the leather, with the button over your head to determine where you would like your necklace to sit.
Once you’ve determined your length, use scissors to trim the ends of the leather on a slight angle.
At this point, add 1 pyramid cut bead to each side of the leather.
Add and end cap onto the end of your leather cord and (Be sure the circle of end cap is facing the same direction as your slider) crimp, or glue.
Repeat this for the other end of your leather.
Use your pliers to open your jump rings. Attach your pears to your end caps, then close your jump rings.