Poinsettia Ornament Kit Instructions

Remove the protective coating from your acrylic sparkle frame (front and back).

Take your wire cut a 3" piece off set aside.   

Now Center 7 pendants on your remaining wire. 

Double your wire to form your poinsettia, bringing wires up.  Pull tightly

Take your 3 inch wire, and center your green crystal.

Bring your ends together, through the center of your flower (If your green bead goes through, you need to pull tighter). Pull the wires up to the wires on your flower.

Twist all wires together tightly, and create a loop (just like the photo).

Use a jump ring to connect your flower to the frame.

Open another jump ring to attach the eye-pin to the top hole of your frame. Close jump ring.

On your eye-pin adda bicone, roundel, pave bead, roundel, and bicone. and wrap.

Attach your last jump ring

3 Comments

AnnMarie Feitt

Date 12/14/2021

It’s been a while, since I’ve done jewelry, will you elaborate on when you say double your wire? Do you mean to put it through beads again or just hold it upwards and bring tightly together to form poinsettia? Thank you. AnnMarie Feitt [email protected]

AnnMarie Feitt

Date 12/14/2021

It’s been a while, since I’ve done jewelry, will you elaborate on when you say double your wire? Do you mean to put it through beads again or just hold it upwards and bring tightly together to form poinsettia? Thank you. AnnMarie Feitt [email protected]

Too Cute Bead

Date 12/21/2021

HI AnnMarie, You'll need to double the wire to keep the form.

Add Comment

TOP
0 Items