Set - up: Take your 7' cord and cut 2 -18" pieces, then 2- 24" pieces. Glue or melt all your ends, cut at an angle and let dry for until stiff.
Example 1 Example 2 Example 1 & 2 Completed
Example 1: Thread 1 24" cord through each of the side holes, leaving an equal portion on each side.
Example 2: Now run 1 18" cord lengthwise, also leaving an equal portion on each end.
Step 1: Now clip to your clipboard and start with your right cord over your guide line and under your left bead cord. Now take your left bead cord over your guide line and up through the loop. PULL TIGHT!
Now take your left bead cord over your guide line and under your right bead cord. Take your right bead cord and go under your guide line and up through your loop. PULL TIGHT!
*Repeat this step 20 more times*
* Flip and do the other side of the bracelet*
Step 2: Flip your cross so that your 2 guide lines are running toward each other and clip in place. Repeat step 1 until the desired number of knots are achieved. We used 15 knots. Try your bracelet on before you finish and adjust as necessary. Add your 2 beads for the tails and tie off.
Example 3 Example 4
Use GS-Hypo Cement or a lighter to secure your ends.
Finish all your ends using examples 3 & 4. Enjoy!