String of love Bracelet Kit Instruction

Begin by cutting 8 inches off of your cord and setting aside (This will be used to create the bracelet closure later).

Cut the remaining cord into 2 equal halves.

Using glue, or a lighter, stiffen the ends of your 2 cords, and use nipper to cut on an angle.

Next, take 2 ends of 1 of your cords, and bring them up through the CZ connector. (This will be a tight fit)

Create a larks head knot. 

Make sure you bring the strings up through the bottom of your CZ connectors rings.

Repeat for the other side of your connector.

Next, cross your 4 strings over each other to create your knot for the back of your bracelet.


At step 8 trim off cord  leaving about 2mm and carefully use a lighter or a small drop of glue to seal cord.

 Once complete, make sure your 4 hanging string are at a comfortable length, trimming if needed.

At this point your can tie a small knot at the end of each string, or choose to tie the 2 strings on each side together as we did in our sample kit.

If you have any questions about these instructions, please leave a comment to help us improve!






Add Comment

TOP
0 Items