Begin by unpacking the contents of your kit, and grab your
tools (nipper, round nose pliers and bent nose pliers).
Use your round nose pliers to curve your wire in the center.
Put the curved end of your wire through the center of your
Run the 2 ends of the wire though your loop to create a bail
for your frames (back and front view shown). Pull tightly to
hold everything in place.
Pull 1 wire up, whiter creating a loop with the other.
Wrap around both ends as you would a head pin. Use nippers
to remove extra wire, and angle your loop to hang on your
leather cord. Slide your pendant on the cord, and check sizing.
Once size, add a fold over crimp to 1 side of the leather. Flatten
one side first, and then the other on top of it.
Your crimp end should look like this. Repeat on the other side.
Finish off your necklace by attaching your clasp to one crimp
end with a jump ring, and simply adding a jump ring to the
other end to lock your clasp into.