- Pair of tweezers
- Round Nose
Remove protective paper from each side of your peeps.
Make sure the etched side of the peep is facing forward (This is where you will add the nose and eyes in a later step.).
On your eye-pin add your bicone, rondel, and bicone and wrap the opposite direction of the bottom loop of the eye pin. Trim off extra wire.
Attach your ear wire.
Now take your peep, open your jump ring, add your eye pin and your peep
Close jump ring.
Lay your peep flat.
Using a tooth pick, add a touch of glue to the etchings of the eyes and nose.
Carefully place Swarovski flat backs.
Now put a small drop of glue over the eyes and nose.
this will hold flat backs in place and dries clear.
Let dry for at least 1 hour.